Power Steering Cooler Replacement

Standard
Wun Tunn Zoop

Wun Tunn Zoop

Wun Tunn Zoop gets a replacement power steering cooler assembly

I finally got around to replacing the bad cooler assembly

The power steering cooler was bad when I acquired the van and I just jumped around it way back when. I’m talking  about totally rotting to the touch. The brackets were so gone you could bend them by hand. It has been that way and I had actually went and bought a replacement  GM unit but I never put it in. It’s importance is that the diesel is a Hydro Boost braking system that uses the PS system for its’ power.Lots more fluid and stress on it.

d2981a4b21491ee0372a338f24174097_ff2be787f3b0b1f75c73f234d8595856

Since I had a free morning I decided to give it a go. After a bit of scouting it was not a bad job.  The cooler is bolted to the frame under the radiator support with the lines going up  to the steering box and power steering pump. The first thing to go was the air cleaner box. It sits right in the the way of all the good stuff. With it out of the way it was an easy go to undo the line to the steering box and the return line to the pump.

The Right Tools For The Job

But … It turns  out this hard line is an 18MM. Of all my line wrenches I did not posses an 18MM. So I went to O’Reilly’s and got one. Easy enough. Then the disassembly began.  With that the line came off with a small bit of effort. Then the return line was a quick clamp removal and a pull. I was smart enough to put a drip pan under the area to catch the PS fluid.

Hair Conditioning

This is where I got a small dose of “what did I just do?” After releasing the lines and the excess fluid was drained into the the catch pan I slid it out of the way. So I thought. As I was undoing the bolts holding the damaged cooler assembly from the radiator support I shifted around a bit to get a better angle and that’s when I  dunked the whole back of my head into the fluid! Oh! Yeah! Nice! But since I was already on it I just went ahead and finished the cooler removal. Then I went inside and decontaminated with a hot shower with 3 shampoos.  Then it was back out to the job.

Hookin It All Up

It was a simple job to embed the new cooler and plumb in the lines. All connected and tight. I topped off the PS system with what I had in the shop. I may need more but that can wait till tomorrow.

 

 

 

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s